Alpha Technologies IPNC1 - mod Bedienungsanleitung PDF herunterladen (Seite 7)

IPDP - installation and operating instructions

For IPDP is necessary used the AC voltage of min. 10Vst - max. 15Vst or DC

voltage of min. 12Vss to max. 18Vss must be energized to “12V” terminal. This

source loading depends on number of modules, since it simultaneously serves

feeding of lighting through visiting cards – at max. number of connected

modules the demand will not exceed 300mA. This source can be also used for

feeding of lock(s), and then it is necessary to consider the electrical lock

demand. In practice the alternating feeder 12V/1A mostly meets these

demands.

The connection of relay contact terminals is shown on fig. 1. The “NO”

designation means an idle-disconnected contact, “COM” means a pin contact

(middle) and “NC” means an idle-connected contact. The contacts of both

switches are galvanically isolated each other and from other guard circuits. The

variants of connection are shown on picture. 2.

Picture 2 Examples of relays connections

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Keine Kommentare

Alpha Technologies IPNC1 - mod Bedienungsanleitung Seite 7