Alpha Technologies IPDP - 00C Bedienungsanleitung PDF herunterladen (Seite 12)

from the second group (parameter 2). The next press of the same

button again selects the number from 

If the button is pressed after the line has been opened (but before the

call is answered), the unit will hang up for the period given by parameter 54, lift

up the line and dial the other group number.

The relay can be controlled by pressing the buttons in the combination

that is set in the preprogrammed code (parameters 32-34). The time between

presses must not be bigger than that set in parameter 53. The unit will lift up

and close the corresponding relay or the period given by parameter 36 . Then it

will hang up.

3.2.1 SlimDoorPhone with Keyboard

The keyboard has two functional buttons 

key symbol = once pressing the numerical

combination is considered as the combination for

control of the switches. The second button X

symbol = when pressing the guard immediately will

hang up.

The incoming person is dialing number as to

be done on phone  the period among button

presses should be lower than the value given by

parameter in keyboard. After this period the guard will lift up and dial the given

number.

3.3 Telephone Caller

A Telephone Caller is a person that is in phone connection with

SlimDoorPhone.

3.3.1 Outgoing call

An outgoing call is a call from the unit (i.e. when a visitor presses a

button). Once the visitor has pressed a button a telephone will ring. On

answering the telephone, you will be able to converse with the visitor. 10

seconds before the maximum call duration (parameter 52) the unit will emit a

tone to warn that the call will end. The call may be extended by pressing the

key as set in parameter 42. A code may be dialled to close the relay

(parameter 35), releasing the lock. Hanging up the telephone will end the call,

as will the busy tone from the PBX.

3.3.2 Incoming call

An incoming call is a call to the unit. After dialling the PBX extension number to

which the unit is connected, the unit will ring for the set number of rings

(parameter 51), the unit will lift up and it is possible to speak. The possibilities

are the same as with outgoing call (Chapter 3.3.1). It is also possible to switch

between Day and Night service.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Keine Kommentare

Alpha Technologies IPDP - 00C Bedienungsanleitung Seite 12