Alpha Technologies APX Series Betreibershandbuch PDF herunterladen (Seite 17)

2.3 Wall-mount Installations

The wall-mount version is equipped with an adaptor bracket allowing the APC or

APL pole-mount enclosure to be mounted on a flat, vertical surface.

NOTE: BEFORE INSTALLING THE MTA, ENSURE THAT ALL OPTIONS HAVE

BEEN INSTALLED AND PROPERLY CONNECTED. REFER TO SECTION 2.11

OPTIONS, FOR INSTALLATION PROCEDURES.

Procedure:

1. Mount the wall-mount bracket to a flat vertical surface. The mounting area

should be located directly in front of a wall stud (2 x 4; 2 x 6; etc.). If such

an area is not possible, appropriate anchors and lag bolts must be used.

Mount the bracket by first marking the location for the holes, using the

bracket as a template (the distance between the holes is 4.5” c-c).

2. Drill out the holes using a 1/4” drill bit. Mount the bracket to the wall using

two (2) 3/8” x 1.5” long steel lag bolts and washers. Make certain that the

1/4-20 (Phillips) screw is located in the upper right-hand side of the bracket

before securing it to the wall.

3. Mount the enclosure to the wall bracket by fitting the slots (in the APC or

APL enclosure bracket) over the rivets in the wall bracket. The enclosure’s

bracket fits on the outside of the wall bracket.

Tighten the screw located on

the upper-right corner of the wall bracket using a #2 Phillips head

screwdriver.

4. Install the Modular Transformer Assembly (MTA) onto the baseplate, (see

section 2.9 MODULAR TRANSFORMER ASSEMBLY).

Photo 2.3.b Photo 2.3.c

Align Slots with

rivets and Screw

2. INSTALLATION

1/4-20 Screw

(upper-right hand side)

Wall Mounting Holes

Photo 2.3.a

Wall Mount Bracket

Tighten Screw

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Keine Kommentare

Alpha Technologies APX Series Betreibershandbuch Seite 17